Groups » Music » The Brightness of Injection Moulded Parts by Air Cooler Mould
Group Info
The Brightness of Injection Moulded Parts by Air Cooler Mould Music
1. If the Air Cooler Mould(FURNITUREMOULD) https://www.furnituremould.com/
is poorly processed, if there are defects such as scratches, micropores, abrasion, roughness, etc., it will inevitably be reflected on the plastic parts, and the gloss of the... more1. If the Air Cooler Mould(FURNITUREMOULD) https://www.furnituremould.com/
is poorly processed, if there are defects such as scratches, micropores, abrasion, roughness, etc., it will inevitably be reflected on the plastic parts, and the gloss of the plastic parts is poor. In this case, the mould should be carefully machined to make the cavity surface rougher and chrome-polished if necessary.
2. If the surface of the cavity is oily or watery, or if there are too many release agents, the surface of the plastic part will become darker and darker. To do this, remove grease and water stains in a timely manner and use a limited amount of release agent.
3. If the plastic parts are too small, the demoulding is difficult, or the force is too large when demolding so that the surface gloss of the plastic parts is good. In this case, the draft angle should be increased.
4. If the air cooler mould is depleted, excessive gas will be left in the mould, which will also cause a decrease in gloss. To do this, check... less
