If the manufacturing precision of the Dustbin Mould https://www.furnituremould.com/ is well controlled, the matching of the mould size and the drawing size may not necessarily meet the requirements of product size and performance. In addition to data... moreIf the manufacturing precision of the Dustbin Mould https://www.furnituremould.com/ is well controlled, the matching of the mould size and the drawing size may not necessarily meet the requirements of product size and performance. In addition to data control during mould manufacturing and injection moulding, perfect products should be injected. More relevant experience is needed in the design and manufacture of dustbin mould. According to the characteristics, sizes and shapes of different materials, the pre-design evaluation and analysis were made, and the post-test evaluation was carried out.
As the shrinkage rate will change with the change of injection pressure, the cavity pressure of single cavity mould should be as consistent as possible, and the cavity pressure difference of multi-cavity mould should be very small. For single-chamber multi-gate or multi-chamber multi-gate cases, the same injection pressure must be used to make the chamber pressure consistent. Therefore, the position balance of... less
